4. Pairing an ANT+ sensor
(for users with ANT+ sensors)

This section describes how to pair ANT+-compatible sensors.

ANT+ sensors can be paired using the AVVENTURA.

* The same procedure is used to pair a Bluetooth® sensor.

Important

Pairing a Bluetooth® sensor
Ensure [Connect] is off in the Cateye Cycling™ app before pairing a
Bluetooth® sensor.

• Pair all of the sensors to be used.

• Do not pair sensors at a race venue or in similar locations where there are a lot of other users. Doing so may cause the sensors to be paired with another device.

AVVENTURA

1. When “GPS Search” or “Ready” is displayed, press OPTION to switch to the option screen.

GPS searching

Ready

Option screen

2. Press MODE to select [Device], and press SS to apply the selection and display the Device screen.

Option screen

Device screen

3. Select [Add Device], and press SS to apply the selection.

Device screen

Enter

4. Select [ANT+], and press SS to apply the selection and begin pairing.

Initiating pairing

* To pair a Bluetooth® sensor, select [BLUETOOTH].

5. Activate the sensor that you want to pair.

Activating the sensor

Ready for synchronization

Sensor
activated

Synchronization complete

If a sensor is found, the name of the sensor will be displayed.

SP: Speed sensor

ISC: Speed/cadence sensor

CD: Cadence sensor

HR: Heart rate sensor

PW: Power sensor

 

Pairing a displayed sensor:
Press SS to confirm and then go to step 6.

Enter

If the displayed sensor does not match the desired sensor:
Press LAP/FINISH to cancel. Press SS on the Add Device screen and pair the device again.

Cancel pairing

* When pairing a sensor with the AVVENTURA, a “C” is displayed after the sensor name.

* Pairing standby time is 5 minutes. After this amount of time has passed, the display returns to the device screen.

* Up to 18 separate sensor IDs—including the computer—can be paired.

6. Enter the tire circumference for sensors capable of speed measurement.

Enter the tire circumference (the length of the outer circumference of the tire) in mm for the tire on which the sensor is installed. (Setting range: 0100 to 3999 mm)

* Sensors incapable of measuring speed are not displayed.

 

Entering the tire circumferenceMove digitEnterIncrease value

 

* “Error” is displayed if a value outside the setting range is entered.

Determining tire circumference

7. Repeat steps 3 to 6 for all other sensors.

Pair all of the sensors to be used.

* Excludes Bluetooth® sensors paired using the smartphone (Cateye Cycling™).

8. Press OPTION to confirm the settings and to return to the measurement screen.

* Once pairing is complete, mount the sensors on your bicycle or body according to the individual sensor’s instruction manual. For more details on mounting/using the CATEYE sensor, refer to the sensor’s online manual.

Important

Data for cadence, heart rate, and power is not be displayed under the initial configuration of the AVVENTURA measurement screen.

Customize the measurement screen to display measured values from paired sensors.

Changing the measurement screen

If all sensors have already been paired, continue to “5. Mounting the bracket, and attaching/removing the AVVENTURA”.

Copyright © 2020 CATEYE Co., Ltd.