CATEYE PADRONE SMART +
Power sensor calibration
To display correct values, the power sensor needs to be calibrated appropriately.
Calibrate the power sensor before using according to the power sensor instruction manual.
If the smart computer displays any value other than 0 when the power sensor is in an unloaded state, follow the procedure below to return the smart computer power value to 0.
Always perform calibration without any power applied to parts to which the power sensor is attached (cranks, etc.)
While the smart computer is connected and measurement is stopped, tap [Calibrate] on the [Trip] screen.
The power value will return to 0 after 3 seconds.